SSR By Hand?

[05SilverTRD]

I am seriously considering ordering some SSR 2,2.5, and 1. I am wondering if these can be applied by hand. I assume so, but I always see poeple applying them with a PC. I know I may not achieve the same results by hand, but I don't have a PC.

 

[CharlesW]

While I haven't used the SSR's, I'm sure I have read where SSR1 and SSR2 can be used by hand with pretty good success. SSR2.5 seems to be a little more work if done by hand.
Personally, I would hate to try swirl removal by hand again. With a PC, it is easy, by hand, it was a lot of work.

Charles

 

[rollman]

:yeah . I use it by hand for small cleanup work. If you have any light scratches or light swirls 2.5 is the way to go by hand . I'm more then sure all of PB's products can be applied by hand. Good luck and have fun .

 

[Poorboy]

:yeah

they can all be used by hand, ...end results can be equal, but there is more effort and time needed than by machine

hint..do small areas and expand a little at a time

 

[rabbi]

Hey Grey! I too have Poorboy's SSR's and I too have no PC. This spring I will attempt to remove some flaws by hand.If I can't get rid of them then I'll make a decision on whether to buy a powertool(cyclo/PC) or not.