Recoat c quartz uk

U

Us1champ

New member
I have a coat on and been using reload

I want to put one more coat on. Can I just coat over everything or take eraser to it and the coat again?




Sent from my iPhone using Tapatalk
 
I pulled this from the Gliss product page at CarPro. Same concept to strip Reload to recoat with another layer of UK. Keep in mind that you only need to wait 45-min to 1 hour if you choose to top with Reload again.

Q. My coating is a few months old and I want to apply Gliss but Reload has already been applied over the coating, can I still use Gliss?
A. No, as Reload will not allow the coating to bond to the paint but if you still want to apply Gliss than the process would be as follows:

  1. Wash with CarPro Reset
  2. Decontaminate with Iron X if necessary
  3. Use CarPro Tar X (this will pull the oils out of Reload that will prevent Gliss from bonding. Use in shade, do not allow to dwell, and be careful around sensitive plastics)
  4. a. Spray and wipe in Tar X into panel with microfiber and immediately neutralize the Tar X by either rewashing the panel or using a waterless wash such as CarPro Ech2o (Make sure to neutralize Tar X before moving onto next panel)
  5. Give it one more good wash with CarPro Reset
  6. Wipe down with CarPro Eraser
  7. Gliss application *If applying over an old coating there is a possibility Gliss may haze up the next day and you can see the application marks. If this happens wiping down the vehicle with CarPro Ech2o or a damp microfiber will remove it.*
  8. If you choose to apply Reload over Gliss than you must wait a minimum of 12 hrs to allow Gliss to cure.
 
You must log in or register to reply here.
Back
Top