imported_RZJZA80
New member
When using a rotary, do you keep it on the whole time like you would a PC, or are you constantly blipping the trigger? My painter, I noticed, constantly blipps the trigger, just wondered if this was normal.
Question to Rotary users
- Thread starter imported_RZJZA80
- Start date
I typically lock the trigger while I'm working so that it stays on. I also use it at a pretty slow speed (I dont think its been on paint above 1200 rpm - I only go higher to check my centering and dry pads).
I personally like to keep one hand palming the head of the buffer, and another between the handle/trigger and the head. I feel it gives more control. I'd really rather have no trigger at all, just the speed knob on the machine and a foot controller/switch.
<starts drawing schematic>
I personally like to keep one hand palming the head of the buffer, and another between the handle/trigger and the head. I feel it gives more control. I'd really rather have no trigger at all, just the speed knob on the machine and a foot controller/switch.
<starts drawing schematic>
AeroCleanse
New member
I generally lock it in the on position when I am working.
Todd@RUPES
Just a regular guy
Blipping is a common technique of hacks (not saying your painter is one) and too this day, much like Stonehedge the exact cause and reasoning is unknown.
Breaking down abrasives in the most uniform manner requires some level of consistent pressure and application, IMO.
As far as leaving it on, most rotaries have a trigger lock, but it really depends.
On my Hitachi I never used the trigger lock because the trigger itself was very sensitive and precise. I would set my max RPM and go from there, using the trigger to vary the spreading, polishing, and refining speeds.
On my Makita I always use the trigger lock as the dial itself is better (more precise and clicks) and trigger is very numb (like a three position switch).
Breaking down abrasives in the most uniform manner requires some level of consistent pressure and application, IMO.
As far as leaving it on, most rotaries have a trigger lock, but it really depends.
On my Hitachi I never used the trigger lock because the trigger itself was very sensitive and precise. I would set my max RPM and go from there, using the trigger to vary the spreading, polishing, and refining speeds.
On my Makita I always use the trigger lock as the dial itself is better (more precise and clicks) and trigger is very numb (like a three position switch).
imported_themightytimmah
New member
I lock it. Blipping it is probably a habit from the single speed rotary days, if he's an older guy.
blackmillenia
New member
I have always locked in my trigger. I have never blipped or heard of anyone doing this before..