Roadster J
New member
Half-way through a detail this weekend my PC started to act up.
It started to run a little slow for the selection on the speed dial (based on sound only) and would not start after I stop to wipe off a panel. Slapping the side of it with an open hand got it running again, but it would slow down on occassion and I had to slap it throughout the rest of the detail to keep it going.
It obviously seems to be an electrical problem and I am hoping it is just the switch, but has anyone had this type of problem or a problem specifically related to the unit's speed controller? If so, how much did it cost to get repaired. Thanks.
It started to run a little slow for the selection on the speed dial (based on sound only) and would not start after I stop to wipe off a panel. Slapping the side of it with an open hand got it running again, but it would slow down on occassion and I had to slap it throughout the rest of the detail to keep it going.
It obviously seems to be an electrical problem and I am hoping it is just the switch, but has anyone had this type of problem or a problem specifically related to the unit's speed controller? If so, how much did it cost to get repaired. Thanks.
