ok im really mad now!

Mliner

Mliner

New member
Well i was just quick detailing the car today with poorboys Spray and wash,i looked deep in the paint and saw some swirl marks.I was thinking about getting the poorboys SSR 2.5?

On my previous wash i used Klasse AIO without Klasse SG. I was thinking about using Klasse AIO again and top it off with SG.

How should i do the following i got very confused on what is first and last.

1-Klass AIO
2-Klasse SG
3-poorboys 2.5

What order should i put them in?and should i wax afer the final step?
 
You,de want to first use the Poorboy's 2.5 then the Klasse AIO and last Klasse SG. In my opinion I find that the Klasse SG gives a Sterile shine so I would go with a carnuaba topper like nattys or Dp max wax after the SG.
 
Getting ready to do the same to my personal car...2.5 or WG total swirl then a good coat of WG sealant and some signature series I think. Time for a summer make over on the suv. :shift
 
How bad are your swirls? 2.5 is quite aggressive, I would first try to remove them with some SSR1 before moving onto the big guns.
Then AIO and SG

"J"
 
Don't get mad get even:D

What you want to do is level your clearcoat, that is the purpose of polishes/ compounds, and how to get rid of swirls. SSR2.5 is a good product to use before the AIO to level the clearcoat, and then the AIO will clear up any residue & possible marring before the application of SG.
 
Antonio Waxer said:
Don't get mad get even:D

What you want to do is level your clearcoat, that is the purpose of polishes/ compounds, and how to get rid of swirls. SSR2.5 is a good product to use before the AIO to level the clearcoat, and then the AIO will clear up any residue & possible marring before the application of SG.
Click to expand...


if he was to use ssr2.5 with a polishing pad are u saying it would be okay to follow up with just aio? dont u think its neccesary to follow with ssr1 or such? or is it because u're using the ssr2.5 with a polishing place instead of a yellor or orange pad?

just curious because i always follow dacp (an equally abrasive polish) with ssr1 even when i used it with a polishing pad. i always felt it wasnt needed, and never saw a difference, only when i used the dacp with a more aggresive pad, only then i saw a difference when followed by the ssr1.

i tried to keep this question very on topic, sorry if i hijacked.
 
I'll try to answer this one....SSR2.5 on a polishing pad often leaves the finish ready for a LSP, so using AIO would do just like Antonio said which is clean up any residue and light haze. DACP is known for needing a follow up product like SSR1, but not SSR2.5 unless you are using a cutting pad.
 
Poorboy said:
I'll try to answer this one....SSR2.5 on a polishing pad often leaves the finish ready for a LSP, so using AIO would do just like Antonio said which is clean up any residue and light haze. DACP is known for needing a follow up product like SSR1, but not SSR2.5 unless you are using a cutting pad.
Click to expand...



thanks steve!
 
You must log in or register to reply here.
Back
Top