My PB Syn1 has arrived.

[TroyScherer]

I can’t wait to try this out. I think I have lined up the perfect candidate for my test a Black Cavalier Z24.
I’ll post up my reveal as soon I can get a hold of the car. I would like to test this side by side with another polish I already have. I’m thinking of M105 or XMT 3 or 4. Would any of these be a good product comparison to use? What is the cut and finish of Syn1 comparable to?

If anyone has any suggestions let me know. Thanks

 

[Dtrick.22]

It cuts and finishes very quickly which I think is pretty neat. But be prepared for lots of dusting

 

[Poorboy]

It cuts and finishes very quickly which I think is pretty neat. But be prepared for lots of dusting

yes, the dusting will be something we address in the next version

 

[tmacsad]

Steve, is the SYN 1 listed on your site?

 

[TroyScherer]

Steve,
Can you give me an idea of the cut and finish ability for Syn1? Does it cut like SSR2.5 or 3? Also what should it finish down compared to? I want to make sure I am fair in my evaluation. Thanks

 

[Poorboy]

Steve,
Can you give me an idea of the cut and finish ability for Syn1? Does it cut like SSR2.5 or 3? Also what should it finish down compared to? I want to make sure I am fair in my evaluation. Thanks

actually i could, but we need feedback and want to see what results each tester gets without pre-conceived expectations

 

[G.T.Subie]

Will this be available at the Detail Weekend

 

[tuscarora dave]

I will be detailing a Dodge Ram tomorrow with what I believe to be Patriotic Blue paint. If it is anything like the PT Cruiser Patriotic Blue Paint it is some hard clear. I intend on using SYN 1 and following it with perhaps SSR 2. I'll try to snap a few pics of the finish after the SYN 1 and before the SSR 2.

 

[Dtrick.22]

Steve,
Can you give me an idea of the cut and finish ability for Syn1? Does it cut like SSR2.5 or 3? Also what should it finish down compared to? I want to make sure I am fair in my evaluation. Thanks

I think it cuts like 2.5....It just does it in half the time. The product will clear much quicker than SSR2 or SSR2.5, also something I like...But I still had to follow up with SSR2 to get the full clarity back, although it finished up better than I expected

 

[Poorboy]

Will this be available at the Detail Weekend

Yes, we will have Syn1 available to use

 

[TroyScherer]

My new 5.5 LC Flat pads are scheduled to be delivered today. I can't wait. Its killing me to have this stuff sitting on my bench and not using it. I wanted to wait as I am switching from 6.5 pads that came with my kit when I bought my PCxp. I hope to have a test done within the week. :yay