Menzerna By PC

Menzerna has many products. Which one are you talking about? I've used Menzerna IP & FP on my PC and they worked great. Haven't tried FMJ on the PC yet and I don't plan on it. FMJ is expensive & I don't want waste product.
 
termigator said:
Haven't tried FMJ on the PC yet and I don't plan on it. FMJ is expensive & I don't want waste product.
Click to expand...



as a newbie i always used to much products when i used hand application. when i purchased my pc i used a little product on the pad then spread it very evenly and thoroughly with the pc. the pc has, for me, made application a simple, clean, and efficient way to apply all the menzerna line. especially FMJ.
 
Typically the product that is wasted is that needed to load the pad up with product and is leftover after you have done the car. I usually don't mind it, but it does quicken your rate of usage a bit.



I've been using Menzerna FPII by PC and it's fantastic. Can't say how much better it would be by rotary though...
 
I have been using the Menzerna line via PC and rotary. I am blown away by Menzerna product both with the PC and the rotary. I was skeptical as are most of using the Menzerna product with a PC, when everyone says they are supposed to be used with a rotary. I have found them to spread accross the paint so much better than any other polishes out right now. The product is very easy to work into the paint and very easy to see how the polish is working the paint. It's a very easy polish to see your work before removing with a towel.



If you are looking into the ulitmate in the Menzerna line, you need to look into the ceramiclear line of polishes from them. I am a huge fan of PO85RD and PO106. They are incredible with the finish that they leave, a deep glossy look. And the fact that Menzerna polishes are oil free, they are LSP friendly!



I know most people are tired of this pic, but here is a pic of myself using the PO85RD via PC, topped with FMJ x2

227kfmj6.jpg




Here's the link as well!

http://autopia.org/forums/showthread.php?s=&threadid=50599
 
FP is pretty much my go to polish to burnish the finish to a magnificent lusture via PC. I alternate between SSR2.5 and IP for moderate swirling.



I love the non-filler nature of the Menzerna polish line.
 
I love using the IP and FP. They help a new guy like me do a close to pro job. I just went to CMA and the semiclear line is very expensive. they give quite a warning on the site about their use. What process do you use, and what pads have you tried. I love the results.
 
You must log in or register to reply here.
Back
Top