Meguiar #2 with PC...is it ok?

A

Acura92

New member
on the Meguiar #2 Fine-Cut cleaner, it says that i must use a rotary. on autogeek's page, it says:



"Meguiarâ€â„¢s #2 Fine Cut Cleaner is not recommended for use with an orbital polisher or by hand application"





so should i return the #2? Or will I be ok with the porter cable? thanks!
 
My limited experience with #2 and a PC was not good.

I believe it needs the high speed of a rotary to work effectively.

There are better products IMO for removing defects.



What are you trying to remove? Swirls, etchings, etc.?
 
The "80" series is more appropriate for PC use. I like #80, but if you need something more aggressive, choose #83 (DACP).
 
Acura92 said:
will it even work if i used it at speed 6?
Click to expand...

If you use it with a PC it will leave marring that you'll have to follow up and polish out anyway.



If want to use a Meg's polish I agree with BigLeegr, go with #83 and/or #80.
 
Last year I tried using #2 by PC, Cyclo, and Rotary. First time I'd used the stuff in at lest 20 years. I didn't like it. I agree with what the others have posted, unless you're using a rotary, I'd pass on this product due to the aggressive nature of its abrasives and the way they don't break down without heat.



I know some peole here use it by PC (and in at least one case by hand), and I used it by hand and by Cyclo back in the day on ss paint. But I just can't get it to work without *way too much* marring. I sure wouldn't use it on b/c paint by PC.



If you need something stronger than #83 or 3M PI-II/II RC, then I'll look into either 1z Ultra/Extra or the Hi-Temp line at TOL.



Take back the #2 and wait until you have a truly appropriate product. It's too bad that #2 is marketed the way it is...it's sorta like the Meguiar's equivalent of TW RC ;)
 
I tried #2 with the PC about a month ago. It just gummed up and made a mess.



I used it with the rotary and it did a beautiful job.



This was on a BC/CC car and I followed the #2 Fine Cut with #83 on a PC then #80 on the PC and then #7 and finally NXT techwax. The results were stunning but it was a lot of work.



I love #2 for when it's needed but it is thin and it slings a lot. I have also used it by hand over small areas before and got great results. But I also recommend against using #2 with the PC.
 
You must log in or register to reply here.
Back
Top