Meg's #21 Seperation

I

imported_Padron

New member
I applied some #21 a couple days ago, it was my first time using the #21. I used a PC with a finishing pad and while I was applying it seemed to seperate with beads of water on the surface of the applied sealant.



I did shake the bottle up quite a bit before applying and it appeared to be mixed properly.



Is this normal or is there a problem with the #21?



Thanks
 
While I have never had this problem (I apply by hand) there are a lot of people who do get this.



I would take a look at this thread over at MOL:



Link
 
I remember mine looking as if it was beading a bit as well..didn't seem to affect the look or durabilty. I think there was a defective batch at one point. I'd call Meguiar's and see..
 
Padron...their was a bad batch of #21...i called customer service and they sent me a new 64oz no questions asked..i just had to send them back the bad batch . I used more than half of it and was seperating alot on me....so far the new batch has given me no problems.
 
You must log in or register to reply here.
Back
Top