I just applied some AIO to a small portion of my car and couldn't see a haze or anything! Is this normal? Should there be a haze? Also, do I apply to sections of the car then buff off or do I apply it to the whole car? The Klasse process would be much appreciated as I am going to apply it all tomorrow! (1xAIO 1XSG)
Help with Klasse!!!
- Thread starter McMustang
- Start date
Brad B
New member
Sometimes due to the color of your car and the thiness of the application it is almost clear. That's ok. You want very THIN coats. Be sure the bottle is shook up.
Let the application dry for 20 minutes then buff off. You don't have to wait until the whole car is done. I do sections at a time. A door, a hood, etc.
Waiting too long can make it a little tougher to remove. Now if you do wait longer don't fret, it will come off, it's just a bit more effort . Use a MF towel moistened with water or QD which will greatly aid removal.
Let the application dry for 20 minutes then buff off. You don't have to wait until the whole car is done. I do sections at a time. A door, a hood, etc.
Waiting too long can make it a little tougher to remove. Now if you do wait longer don't fret, it will come off, it's just a bit more effort . Use a MF towel moistened with water or QD which will greatly aid removal.
imported_killerjg
New member
With Klasse and Z I found I had to break old habits of looking for a fully hazed car when applying these products. They go on so thin and are usually a challenge to see when applied correctly.