I just tried to switch the backing plate on my PC from the 6" to a 4" backing plate. The problem I am having is I cannot get the backing plate off. I used the wrench and tried to turn the backing plate in a counter clock wise manner and the darn thing won't budge. Am I doing something wrong and what posssible solutions are there?
Help Please
- Thread starter Lou K
- Start date
Setec Astronomy
Well-known member
You are using the wrench to hold the spindle of the machine and then turning the backing plate by hand, correct?
Accumulator
Well-known member
Assuming that your wrench is firmly on the spindle's hexagonal shaft, you just need to apply more force. Seems funny that it's on there so firmly though...I'm also assuming you're turning it the correct direction 
Accumulator said:Assuming that your wrench is firmly on the spindle's hexagonal shaft, you just need to apply more force. Seems funny that it's on there so firmly though...I'm also assuming you're turning it the correct direction
Finally got it off with the help of a friend. It was on very tight and the threads had rust un them; guess the extra force helped.
Thanks
Brian_Brice
New member
In the future if it happens again you might want to try a standard wrench ( I think it's a 9/16) because it can grab a little better and feels better in your hand.
optimusp517
New member
Make sure to clean out the rust and use some anti-seaze *spelling* on the thread. It should prevent any future issues.