EZ Creme Glaze II w/ UPGP

M

mini viper

New member
Done some searching and haven't found a definitive answer as to whether you can layer EZ Creme Glaze II w/ UPGP. I understood that it *may* have a small amount of cleaners in it. I assume, based on this, that the glaze will clean off the UPGP if layered on top like DWG is able to do. Also, what's the difference between glazing and applyin LSP and applying glaze between LSP layers?



Thanks for the replies :).
 
You should be able to put UPGP over the EZ creme glaze without issue. It's pointless to apply EZ creme glaze over any sealant.
 
the new version of ez glaze has no cleaners in it.



i am using this and DWG with fantistic results with Opt-Seal.
 
For a n00b, what's the benefit of layering the glaze and LSP? Seems some people like to put alternating layers of DWG and a LSP... Good to hear the new one doesn't have cleaners, looks like I'm ready to place my large order of stuff :).
 
I put EZ Creme as a base for UPGP with no issues - think it added a bit more to the look than the PPP. I just layered DWG over UPGP as well and it adds to the look and I'll continue to do it :D
 
On Chemical Guys website it does not show ceaning as an attribute of ez glaze where it is listed 1-10 process shime depth etc..



previously on the website it did show a 1 for cleaning whereas now it shows nothing.



Ez glaze gives a brighter truer shine than Danase wet glaze it has some fillers in it both are great products.
 
You must log in or register to reply here.
Back
Top