Combo for white

I

imported_Mik

New member
I am about to detail my white GTR which is basically a garage queen. There are a few very fine swirls, but not many as I did the whole car in SSR2.5 about 6 months ago



My plan is as follows:



1) SSR1 with white LC polishing pad

2) PwC with white LC polishing pad (or PP, see below)

3) EXP with grey LC finishing pad

4) Natty's by hand with megs foam applicator

5) QD when needed with Crystal Mist



Anyone have any suggestions/comments?



Would I be better to go over some areas with SSR2 and a cutting pad as needed before the SSR1?



Will the EXP stick to the canuba left by the PwC, or would it be better to use PP instead?



How long should I leave the EXP before applying Natty's? I'm planning to do it the next day.
 
I agree with papi, I'd go with the ssr2 before ssr1 to get out any minor swirling. This is a crutial step because it will determine the depth, wetness, and overall look.



Also, I'd go with PP instead of PwC for EX-P's sake. You will get a little more duarbility out it this way.



Let EX-P cure for at least 24 hours before applying Natty's, and I'd actually do two coats of EX-P instead of one.......24 hours apart, of course. :bigups
 
You must log in or register to reply here.
Back
Top