Combo Advice

J

jostan

New member
PO203 + DWG + UPGP + FK425. Any problems with this combo? Issues with bonding or redundancy? Thanks.
 
Jostan, I can't speak specifically to 203 as I haven't used it yet, but as a general rule, I use purple foamed wool for correction work, and then a finishing (zero cut) pad for best gloss. 203 being a combo product (correction and finishing polish), you can do both: use a PFW for correction, then a zero cut foam pad to finish for best gloss. Or, if you just want to do a one step, I'd use a white LC foam pad.
 
SuperBee364 said:
Jostan, I can't speak specifically to 203 as I haven't used it yet, but as a general rule, I use purple foamed wool for correction work, and then a finishing (zero cut) pad for best gloss. 203 being a combo product (correction and finishing polish), you can do both: use a PFW for correction, then a zero cut foam pad to finish for best gloss. Or, if you just want to do a one step, I'd use a white LC foam pad.
Click to expand...



Thanks. Still deciding if I should do a 2 step or just try the 1 step using white pad...dang choices.
 
When in doubt ... take the two-step method.

You'll hate yourself if you try one-step and it's not to your satisfaction.

Everyone is proud of a job done right!
 
If I am going to do a 2 step polishing job, I'm not going to use a "combo" polish for both steps. I would use the P203 for the first stpe, then finish with a true finishing polish on a finishing pad. I think you'll get a better end result.
 
You must log in or register to reply here.
Back
Top