SVR
Dream Machines
I have a couple bad blemishes on my car's finish that were there when I bought it back in august
Most of my work is done by hand. I have a pro rotary but need some edge 2000 pads and more practice, however my new job (if i get it) will give me the training I need.
Is there a point when you have to break out the rotary to get blemishes and certain scratches out.
I am currently refinishing the PPG 2K clearcoat galaxy blue metal flake paint as I was lazy when I first got the car and skipped some steps
This is what I am doing, have been doing it panel by panel due to time restraints.
CM clay
4 Star UPC (an extra fine cut might be required but I don't want to)
Poorboys SSR 3, 2.5 X 2, 2.0, Meg's #9, Menz IP/FP, Dinitrol 7020 polish, klasse aio, sg x 4, upp x 2, wolfgang x 2
Alot of steps I know but the finish so far is awesome with the four klasse sg's on the completed panels so far. Left side doors to go yet.
This pic was done with flash on as the light was bad in the shed
Please give me a quick run down on what I need to do to remove these things.
Most of my work is done by hand. I have a pro rotary but need some edge 2000 pads and more practice, however my new job (if i get it) will give me the training I need.
Is there a point when you have to break out the rotary to get blemishes and certain scratches out.
I am currently refinishing the PPG 2K clearcoat galaxy blue metal flake paint as I was lazy when I first got the car and skipped some steps
This is what I am doing, have been doing it panel by panel due to time restraints.
CM clay
4 Star UPC (an extra fine cut might be required but I don't want to)
Poorboys SSR 3, 2.5 X 2, 2.0, Meg's #9, Menz IP/FP, Dinitrol 7020 polish, klasse aio, sg x 4, upp x 2, wolfgang x 2
Alot of steps I know but the finish so far is awesome with the four klasse sg's on the completed panels so far. Left side doors to go yet.
This pic was done with flash on as the light was bad in the shed
Please give me a quick run down on what I need to do to remove these things.
