Black car and the SSR2.5

K

kikim

New member
Usually, I work with the Mezerna, 3M and Meguiars products. I decided to test the PoorBoys products then I bought the SSR2.5 and the SSR1.

With PC and on a black car, with which pad and at which speed to work them?
 
How bad are the defects you're removing? SSR2.5 works pretty well with a polishing pad is the swirls aren't that bad, too. The nice thing about that is it doesn't leave hazing like 2.5+cutting pads sometimes do.
 
Picus said:
How bad are the defects you're removing? SSR2.5 works pretty well with a polishing pad is the swirls aren't that bad, too. The nice thing about that is it doesn't leave hazing like 2.5+cutting pads sometimes do.
Click to expand...



I want remouve swirls like this w SSR2.5 in black color...

swirlfronthoodSMALL.jpg
 
if you have light to moderate swirls, i wouldn't go any further than a polishing pad. SSR2.5 is some abrasive stuff that shouldn't have any problems taking out that level of marring with a polishing pad...at least I haven't. Anywhere between 5-6 should do on the PC.
 
Ya, try a polishing pad first and move really slow @ speed 5. Might take 2-3 passes, but you'll likely get them out and you'll leave it LSP ready. Cutting pad will work, but you'll probably get hazing and have to go over it with a polishing pad anyway.
 
Picus said:
Ya, try a polishing pad first and move really slow @ speed 5. Might take 2-3 passes, but you'll likely get them out and you'll leave it LSP ready. Cutting pad will work, but you'll probably get hazing and have to go over it with a polishing pad anyway.
Click to expand...



I want to usually work like I work with the other products...

SSR2.5 with Yellow pad (or orange pad) + SSR1 with white pad ... and finish with AIO and a good carnauba wax.

Do the Poorboys products work well with this process?
 
You must log in or register to reply here.
Back
Top