Applying and Polishing over Vinyl Graphics?

I

integraoligist

New member
Ok, this is the procedure i was planning on doing:



-Wash NXT

-Clay

-Wash NXT

-#83 with DAP

-#80 with DAP

---

I'm going to be adding a few Vinyl graphics (spider webbing deisgns) so...

---

-Rubbing Alcohol with MF Towel (only in areas where Vinyl will be applied)

-Apply Graphics using Squeege, apply dishsoap and water to "move and set" graphic into place

-wash NXT

-Sealent

-Wax







Now, should I switch the order of anything? or should something else be changed?

I'm worried about causing micromarring and scratching the freshly polished finish when i apply the graphics....



Also, in 6 months when I strip the wax and sealent off and reapply... will I be able to use #83 and #80 with a DAP over the Vinyl (if nessesary)?



Thanks!
 
Chemically or physically. You should be okay running DACP over the vinyl with a PC once or twice but I wouldn't make it an every detail thing. My suggestion is using AIO in that area, maybe VM or a glaze to keep webbing at bay throughout the time you have the graphics applied. I would also think about taking them off after a while as your paint will fade around them making it really hard to get off! :soscared:
 
pssstue said:
Chemically or physically. You should be okay running DACP over the vinyl with a PC once or twice but I wouldn't make it an every detail thing. My suggestion is using AIO in that area, maybe VM or a glaze to keep webbing at bay throughout the time you have the graphics applied. I would also think about taking them off after a while as your paint will fade around them making it really hard to get off! :soscared:
Click to expand...



this is going on a garaged showcar. i'm sure the sun won't fade the paint around the area :clap:
 
You must log in or register to reply here.
Back
Top