Anyone still use Meg's #80?

I use #80 on every car I detail it is a versatile amazing polish I would say. It gives great results on almost any paint.(It seems that some toyota paint is harder from using it on my truck, I am waiting till spring to bust out the #83 on my paint).
 
I use #80 quite a bit, It is my go to product. I am going to start to try new products when it warms up.
 
I will never be without it in my polish arsenal, actually i will always have #83, #80 and #82 on hand at all times.

They are honnest to god great polish's.
 
I see 80 is a 4 on my handy dandy scale of products, and a 4 is the mildest of the light cut products, just a notch above Polish, #82 falls into the top of the Polish block. So, would ya'll say that 80 is equal to XMT#3? That's my go-to product for paint that is oxidized and has a few light scratches, I hit it with a PC & LC orange pad and it finishes down glossy enough for the LSP. I'm looking to try something new after my XMT#3 runs out.
 
dietoremain said:
I use #80 on every car I detail it is a versatile amazing polish I would say. It gives great results on almost any paint.(It seems that some toyota paint is harder from using it on my truck, I am waiting till spring to bust out the #83 on my paint).
Click to expand...





Totally Agree !!



I like the results I can and it's fairly easy to work with.

I picked up a gallon ( had to order it ) at O'Rielly's for under $20.

I've had good luck using a Megs Yellow Polish pad on the PC.

Pretty handy product for that price.



One of my favorite Go To products.
 
80 ROCKS!!! Okay so that may be a bit overboard, but, it is one of my favorite polishes to use. It gives stunning results when worked properly. My only complaint about it is that it can be a bit tricky to use during the hot dry summer months in Calif.
 
I still use it a fair bit too, as I like the glazed deep and wet finish it leaves behind. Very effective finishing polish, and also a good general light swirl remover as well.
 
Bioman said:
What has more Cut:blackfire src or #80?
Click to expand...



Blackfire SRC via Rotary has alot more cut versus #80. Otherwise via PC I'd still have to say it cuts more than #80. It varies on Pad/Pressure/Paint.
 
You must log in or register to reply here.
Back
Top