A Newbies Experience with Megs UC

U

Up To Eleven

New member
I would spread Megs UC with my 7424 at speed 1 then increase to 4. After 1 pass the UC was almost totally gone. I started using more product and used almost the whole bottle in one application. I was expecting it to look like vaseline after 3-4 passes but it was more like chalk which stuck to the car after 1-2 passes. I was able to remove the sticky substance with a MF and much elbow grease. Any suggestions or observations?



The process on the '05 Prius was...



Wash - Dawn

Clay - Sonus green + Megs LT 50/50

Wash - Dawn

Polish - PC 7424 + 4" LC Orange + Megs UC

Wash - Turtle Ice

Wax - Colonite 845



The paint looked good and was extremely slick. I could see some scratches disapear and others diminish. Overall, I am happy with the results but was confused with the reaction of the UC.



I planned to follow the UC with #80 on a white finishing pad but didn't think I would notice a difference. This was my 2nd time to use the PC. Any feedback would be much appreciated.
 
You're using way too much product. You should be just fine with 3 pea-sized drops (I fill in three CCS holes) of product for a section of panel 2ft x 2ft. It doesn't seem like much, but it's enough to do the job and using that amount won't leave you buffing off tough residues later.



I have also used UC and I was pretty impressed. On hard Audi paint, it was roughly equivalent to SIP, both on an orange pad with a Flex.
 
You must log in or register to reply here.
Back
Top