A lot of dusting with LC pad and 2.5

D

drewdown

New member
After using the same pad for awhile with the PC. it seems as though it would dust immediatly after I started working it in.



I would add a little SSR2.5 everytime I statred on a new spot, but it would dust at first, stop dusting and then dust some more.



Any ideas what I am doing wrong?
 
What you are experiencing is product left in the pad from previous uses. I'm going to guess you are using the white or orange LC pad, as both are diffucult to completely flush free of product when washing. When washing, rinse and flush (squeeze or spin out) numerous times. This will help.
 
I am assuming you are referring inbetween uses? Because its while I am detailing that I am getting dusting. I mean way more than I should. So I am doing something wrong, just dont what. Too much product each time?



And on the LC white pads where is the best place to put the product? on the edge in the middle of the pad? or inside/oustide of the edge?
 
SSR is a "duster." But if you take a brand new pad and use it just how your are now, you won't get half the dust...right? So what I'm saying is that you have dried product in the pad from usage other days. Wash as good as possible.



Those white pads are really hard to get clean.



Doesn't really matter where you put the product on a PC...but I prefer to put a very very thin ring aound the pad aoubt 1 inch from the edge.
 
You must log in or register to reply here.
Back
Top