scary bill
New member
This is my truck that I bought new in 2001. It has 84000 miles and is very much a truck. It has seen mud, gravel, blizzards, wind storms, hail storms, and much other nastiness. I don't always have the time for detailing like I would want, so I make do with what I got.
Of course I washed with PW and Foam cannon last week:
The before didn't shoe any of the filth, so here’s an after wash
To finish detailing I had to wait about a week (no TIME)
The full process was:
Wash with ONR
Clay at same time using clay magic and onr as lube
Amorall Tire Foam to clean tires; spray on dwell 5 min wipe excess
Plastic trim was treated with Wizards Trim Restore
Glass cleaned with Invisible Glass
Polish Paint
*Problem areas got a pass or two using Purple Wool and OC to cut some deeper issues first.
-OP X2 by 6.5" LC white @ 1200-1500RPM and final pass @ 900RPM
-3M UF SE 6.5" @ 1200RPM and final pass @ 900RPM
Sealed
KAIO by PC LC blue speed 3
DWG by PC LC blue speed 3
PB EX-P by PC LC blue speed 3
After wash and clay
I have had a good wash technique so there aren’t a lot of swirls. Like I said I cut some of the worst areas with the wool, the befores didn’t turn out. Most of the scratches I have are deep and spread out and will NOT polish those all out on this one. The biggest issue I have is with oxidation and normal wear on the clear. It just needing a real good "make shiny again" polishing.
Before
After
reflection in door
More to come :xyxthumbs
Of course I washed with PW and Foam cannon last week:
The before didn't shoe any of the filth, so here’s an after wash

To finish detailing I had to wait about a week (no TIME)
The full process was:
Wash with ONR
Clay at same time using clay magic and onr as lube
Amorall Tire Foam to clean tires; spray on dwell 5 min wipe excess
Plastic trim was treated with Wizards Trim Restore
Glass cleaned with Invisible Glass
Polish Paint
*Problem areas got a pass or two using Purple Wool and OC to cut some deeper issues first.
-OP X2 by 6.5" LC white @ 1200-1500RPM and final pass @ 900RPM
-3M UF SE 6.5" @ 1200RPM and final pass @ 900RPM
Sealed
KAIO by PC LC blue speed 3
DWG by PC LC blue speed 3
PB EX-P by PC LC blue speed 3
After wash and clay


I have had a good wash technique so there aren’t a lot of swirls. Like I said I cut some of the worst areas with the wool, the befores didn’t turn out. Most of the scratches I have are deep and spread out and will NOT polish those all out on this one. The biggest issue I have is with oxidation and normal wear on the clear. It just needing a real good "make shiny again" polishing.
Before

After


reflection in door

More to come :xyxthumbs