1Z Metallic Polish

C

CTDiesel

New member
I have two one liter containers of the 1Z Metallic Polish, both unused until now, and the contents are extremely thick. So thick that it cannot be poured from the container.



I've tried shaking for 5-10 minutes and there is no improvement. Can I cut it with a solvent or should I simply dispose of both containers. If a solvent can be used, what would be the best choice?
 
Those sound like the round, 1-liter cans of the Pro version. Yeah, it's thick stuff; it's supposed to be that way. You can stir it up with a *very clean* tool like long screwdriver but it'll still be thick and you'll always have to wrestle with it a bit to get it out of the can.



Don't cut it with a solvent, don't throw it away (well, you could toss it my way ;) ). Just shake the can until you get a blob of it to plop out onto your pad and then spread it around. If it's too much of a pain you could always sell it to somebody who appreciates the stuff; I have a *lot* of it, otherwise I'd be trying to buy it off you.
 
I thought there must be problem as the consistency is similar to a chassis grease. I'll try to transfer to another container that will make it easier to dispense.



Thanks for the help.
 
Good stuff! Don’t let it go bad.



I also have the 1Z liter bundle . . . best method I’ve found is to transfer from the can to a ketchup bottle. Despite its thick consistency, it’s easy to squeeze onto finish or pad :grinno:
 
You must log in or register to reply here.
Back
Top