Search results

Doing some mild correction work on an M3. The rear quarter has been replaced. On the replaced panel the paint depth is ranging from 58-86 microns. The rest of the car is fine. That is a little thinner than I would like to work with. I was thinking about using D151 on a black pad and leaving...

This was probably one of the most challenging correction jobs I have ever done. Of course its black, riddled with defects, tight body lines, low to the ground, paint difficult to work with, on and on. This particular Mercedes paint did not like microfiber pads at all. The paint seemed to be...

1969 Camaro Pro Street This 1969 Hugger Orange Camaro was a former Drag Car now Show Car was suffering from bath towel induced swirls and scratches. A three step paint correction was performed with the 3rd step being Carpro Essence. The car was then coated with Gyeon Mohs, then Gyeon Cancoat...

69 Yenko Camaro Tribute-corrected and coated Tampa Fl 69 Yenko Camaro Tribute-corrected and coated This car pretty much had a wide range of defects, swirls, sanding scratches, orange peel, dieback/shrink back, buffer trails. Paint was leveled with LC thin purple foamed wool pads with M105 and...

Hey Guys Hope everyone is having a good 2017 so far. I just finished up this sweet 57 Chevy. The car was painted about 3 months ago. I had tons of overspray to remove covering the body and wheels. I used an aggressive clay towel and clay to remove the over spray. Some light sanding marks...

So I am back at the garage mahal for another job. This 1964 nova is fully custom in every way. Paint was a little hazy with swirls mostly from too many wipe downs but I would not say it was in poor condition. Correction was done with Rupes 21 with a microfiber cutting pad with D300. Second...

I don’t normally go mobile but when it July in Florida and the customer lets you use his air conditioned shop you tend to make exceptions. Over all condition was not that bad. Paint was corrected with Griot’s Fast Correction Cream with Meguiars burgundy disk. In some spots I had to jump up...

I have done several write ups over the years and I am not doing anything different but I can not get my pictures to load. I am copying the link from my photobucket account pasting it in the box after clicking on the little picture in the tool bar but the picture will not load.

A customer of mine recently picked up this super charged 68 Chevelle. The car was pretty clean when I received it. Moderate swirls and a fair amount to orange peel. The car is more of a driver than a show piece and the owner did not want the expense of wet sanding the entire car. I proposed...

I was asked to get this 2014 GT Blue Viper ready for resale. I don’t normally do mobile jobs but I made an exception in this case. As you will see it was a very cramped one car garage that I was forced to work in. The owner is putting the car up for sale to purchase a 2016 Viper ACR. The...

2010 BMW M3 3 step paint correction coated with Optimum Gloss Coat then topped with Opti-Seal. Hood vent totally packed with compound. Later removed for proper cleaning. sorry no outside sunlight pictures this time. thank you

I finished this one up a while ago. The paint was a bit tricky to figure out but I settled on Carpro Fixer on an orange LC pad followed by carpro reflect on a white LC pad. Correction was done using a Rupes 21 with a 5 inch backing plate. Then the car was coated with Cquartz UK...

Hello Everyone I just finished up this very nice 2013 Camaro ZL1. The car had less than 7500 miles on the car. Below is picture of the car right after it was washed. The car looks pretty good right? This is where the story starts to get interesting. Let’s pull the car in the garage dim...

Has anyone used any coatings on single stage paints? If so what did you use? Thank you

Pair of GT-R’s that I recently completed. First up 2010 2 step correction with Meguiar’s correction compound and microfiber pads. Finishing completed with Sonax perfect finish with buff and shine green pads. All the correction was done with Rupes Bigfoot. I used 2 coats of Menzerna power...

2013 Nissan 370Z-Cquartz Tampa, FL I have always had a place in my heart for Z cars after owning a ’90 Twin Turbo myself at one time. The owner purchased the car wanted to have the paint corrected and coated due to the fact that the car sits outside 24/7 in the Florida sun. The car...

I worked on this Camaro about 4 years ago. At that time I only preformed a light polish and paint protection. This time around the work was a lot more extensive. The 15 year old lacquer paint had water spots minor swirls and was very hazy. The wheels had water spots and tarnish. The...

Looks like the balck F-40 featured on Fast and Loud sold at Barrett-Jackson. Gotta love it. Maybe they should have left it red. LOL http://cdn.boldride.com/gas-monkey-garage/1992/gas-monkey-garage-ferrari-f40.960x638.Jun-25-2013_09.04.09.227875.jpg

I recently finished this 1986 Porsche 930. The paint was fill with swirls and RIDS. The black single stage paint was a bit tricky to work with. The curvey body lines and small tight areas did not help either. It turned out to be a 3 step process. I started with #105 on a microfiber cutting...