Recent content by Warez

Our house was built about a year and a half ago. The driveway is cement, but it shows the tire tread marks/stains very easily. I've cleaned the driveway a few times, but it takes quite a bit of work. The pressure washer helps a little, but I end up having to use some detergent, a scrub brush and...

Seriously. All I ever read is about people using SSR2.5 and SSR1... never SSR2. Why?

I recently bought a new Avalanche from a dealership around 70 miles away(I don't want to drive back). Apparently, I was so excited to get a new vehicle that I didn't notice the stains on the carpet. It looks like someone spilled chocolate milk or coffee or something on the center console and...

For all those grooves or crevices where the PC can't reach, do you just use the same swirl remover product by hand? Foam applicator or MF or what? Thanks...

Around three and a half years ago, I bought a PC 7336. I also purchased a velcro backing plate and two pads. I ended up not using any of these. Well, now I have a reason to use the PC again and would like more info about the pads. I have no idea whether they are suitable for light swirl removal...

Around three and a half years ago, I bought a PC 7336. I also purchased a velcro backing plate and two pads. I ended up not using any of these. Well, now I have a reason to use the PC again and would like more info about the pads. I have no idea whether they are suitable for light swirl removal...

How long should it take to clay a four year old car that's never been clayed? I'm in the process of getting my '02 Trans-Am ready to be sold and I've already spent over 18 hours claying it... and I'm still not done! It just seems to be taking forever to get all the stuff I see off the...

I was in need of some more MF drying towels. After reading about Vroom MF towels here in the forum, I decided to swing by Target and pick some up. I purchased two Vroom MF Drying Towels(23.5"x40") and one Vroom MF Chenille Wash Mitt. (The wash mitt is bright orange and looks like they just...

I read a post a few days ago that had a link to a page comparing several different products and their levels of aggressiveness. (3M, SSR2.5,2,1, IP, FP, etc) Now, I can't seem to find the post or the page. Anyone have any idea? Thanks...

It's been a while since I gave any of my cars a good detailing. I now need to detail a car I'm going to sell. I have some products that have been sitting around for about 3.5 - 4 years and I'm wondering if any of these products are still good. Kept inside house - P21S Inside house then...

I recently bought a 2007 Avalanche(Black) and of course want to protect it and give it a full detail. I'm wondering what to use for light swirls. I've searched and read, but everything I've read deals with heavier swirls than those on my Avalanche. I don't want to use something too agressive...

The hood on my car(Black '02 Trans-Am) has particularly soft paint. (It was painted separately as part of the WS6 upgrade) Even claying scratches it! After claying a small section, I rubbed some 3M SMR by hand over it. That seemed to do the trick. I have a PC, however, I'm afraid that the 3M...

I went to my local auto supply stores looking for the Meg. foam applicators I've seen recommended here, but couldn't find any. I did, however, find "Viking Applicator Pads". Anyone have any experience with these. I'd like to use them to apply Zaino(Z5). Viking Applicator Pad - Pic#2...

My other car is a '94 Sentra... it looking pretty bad.:( I'm just wondering if there's any hope for it at all. WARNING! The following pictures are not for the weak of heart. Picture 1 Picture 2 Picture 3 Picture 4 Picture 5 Thanks, -Gabriel

I've clayed another one of my car's before and didn't have a problem. But for some reason, on my new car, now I'm getting scratches! The car is new and I Dawn washed it a few days ago. It's been in the garage ever since. I used a new Zaino clay bar and the water/Z7 mix for the lube. I...