Recent content by KevinVanCaster

I have carnuba wax over a sealant, after a while it starts to water spot and get spider webbing. Can I pull just the wax off, to replace with fresh. I would rather not lose the sealant in the process. Thanks, Kevin

Is there anyone around Spokane Wa. that would be willing to look at my car and point me in the right direction?? I will be in portland for the Indy car races in a couple weeks, if there is anyone over there. Just would like a professional to see what I am working with. Thanks, Kevin

Is there anyone around Spokane Wa. that would be willing to look at my car and point me in the right direction?? I will be in portland for the Indy car races in a couple weeks, if there is anyone over there. Just would like a professional to see what I am working with. Thanks, Kevin

Has anyone used the abrasive pads on their car? http://www.cyclotoolmakers.com/discs/discscomp.html Kevin

Can Machine polishing cause an orange peel look. At certan angles it looks like orange peel, all other angles looks like a pice of glass. I don't recall if it looked this bad before polishing. (orange peel look) Thank's Kevin

Just got my new Cyclo it works GREAT ! I had repaired some rock chips and sanded them down with 2000 grit then polished out with scratch X. This worked it took a lot of times and a lot of pressure. My car has other scratches on it and I did the whole car with scratch X. I would like to use...

I have a black car that in the sunlight looks pretty darn good. But if I inspect the finish up close with a hand held fluorescent light it looks somewhat gray and full of scratches. Are these scratches something that can be removed without cutting clear through the clearcoat? Is this...

Hi guys, Can Meguiar's #20 Sealant be layered?? Thanks, Kevin

Hi Guys, So tell me not in terms of ease of use etc. How does a Costco 10" orbital compare to a PC in the actual finish on the car? Thanks, Kevin

Hi guys, Hey I can't do the whole detail and seal in one weekend. So how should I do this? I am going to start with claying then SMR. After that #7 Glaze, followed by # 20 sealant. After curing waxing with #26. My question is "At what point should I stop for the weekend to pick up...