Recent content by BikeFreak

Just did the standard wash/clay/polish/glaze/wax on my truck. I used Red Moose Glaze and topped it with Moose Wax. I am debating whether or not to add another layer of Moose Wax. Does anyone have experience with layering CMW, just would like to know if it worth the extra step. Daniel

I recently had my front fender replaced due to deers bad decision to cross the road at the wrong time. I would rather try to bring the back depth of the black paint on the door (and the rest of the truck) to match the fender, rather than have the body shop redo the fender and blend into the...

I know this is the opposite of what we do on this forum.... but.. I had my front drivers side fender replaced on my 'black' 05 Ford F350 after a deer so conveniently ran into me at 60mph. It is a very close match when you look at it outside in the sun and probably most people will never...

How often can I use Menzerna IP or SIP? I used IP on my truck and I removed all the swirls, but can I use it again in a few months? I won't need to repair the paint as much next time. I am concerned that the IP or SIP will remove a little bit of the clear coat each time I apply it, is this...

I ordered my Menzerna IP and FP and they arrived late this afternoon so I had a chance to test them out. I also ordered 3 white and 3 Gray CCS 5.5 pads. My truck looks real good after a wash out in the sun..... but once I got it in the garage under the halogens... well let me say it looked...

My first deep clean and detail on my 2005 Black F350. Here is a pic of the side, it was the best shot I could get. The paint I think is in really great shape, just needs a deep clean and polish. You can see the vertical lines from the sun reflection, not sure if this is marring or spider...

I applied my first layer of Klasse SG this morning. True to its nature it is difficult to get the last bit of haze off that you can only see under the halogens. Is it ok to use quick detailer to get that last bit of haze off before I let it cure for 24 hours? I am using ClearKote QS. If...

It seems Armour All doesn't get much attention here. I have been using it on my Tacoma's fender flares and all the textured plastic. I am going to order some 303 here soon to test it out. I would like something that shines up the plastic nicely. Also all the rubber trim needs to be...

I just did a 3 step process with my silver '04 Tacoma... Clay bar Klasse AIO 1x Klasse SG 1x Does anybody use only the AIO and not top it with SG? The AIO felt smoother than the SG when it was applied. What are the advantages of topping the AIO with SG? I found the AIO much easier to...

Newbie here. I just purchase my first *new car* last weekend. A 2004 Toyota Tacoma 4x4 ext cab V6 TRD with the Lunar Mist Paint (silver). My question is; Do I have to let the paint cure anymore before I apply my first coat of wax. I am not sure if this is an urban myth or not. I would...